CHAUVET DJ GigBAR 2 All-In-One Lighting System - Manual (Page 22)

Page 22 of 156 GigBAR 2 User Manual Rev. 7
Proper Usage This product is for overhead mounting only. For safety purposes, Chauvet recommends
mounting lighting effect products on steady elevated platforms or sturdy overhead supports
using suitable hanging clamps. In all cases, use safety cables. Obtain appropriate mounting
hardware from your lighting vendor.
International laser safety regulations require that laser products must be operated in the fashion
illustrated below, with a minimum of 3 meters (9.8 ft) of vertical separation between the floor and
the lowest laser light. Additionally, 3 meters of horizontal separation is required between laser
light and audience or other public spaces.
CAUTION! Use of controls, adjustments, or procedures other than THOSE specified IN
THIS USER MANUAL may result in hazardous radiation exposure.
• Chauvet requires the placement of sandbags on the base of the stand for added
stability.
• IMPORTANT: DO NOT go past the printed stopping point on the mast.
• DO NOT over-tighten the knob at the tripod mounting insertion point, as it may damage
the mast of the stand.
• DO NOT use this stand in any manner for which it was not intended.