Connecting the projector to the internet – BenQ LH730 4000-Lumen Full HD LED DLP Projector User Manual
Page 26
26 Operation
Connecting the projector to the Internet
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the
other end to the RJ45 port.
2. Make sure the menu type is
Advanced
for how to switch
to the
Advanced
OSD menu.
3. Go to the
Advanced
menu -
System
>
Network Settings
menu.
4. Highlight
Wired LAN
and then press
OK
. The
Wired LAN
page is displayed.
5. Press
/
to highlight
DHCP
and press / to select
On
.
6. Press
/
to highlight
Apply
and press
OK
.
7. Go back to the
Network
page.
8. Press
/
to highlight
AMX Device Discovery
and press / to select
On
or
Off
. When
AMX Device Discovery
is
On
, the projector can be detected by AMX controller.
9. Please wait for around 15 - 20 seconds, and then re-enter the
Wired LAN
page.
10. The
IP Address
,
Subnet Mask
,
Default Gateway
, and
DNS Server
settings will be displayed.
Note down the IP address displayed in the
IP Address
row.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press
/
to highlight
DHCP
and press / to select
Off
.
3. Contact your ITS administrator for information on the
IP Address
,
Subnet Mask
,
Default
Gateway
, and
DNS Server
settings.
4. Press
/
to select the item you want to modify and press
OK
.
5. Press / to move the cursor and then press
/
to enter the value.
6. To save the setting, press
OK
. If you do not want to save the setting, press
BACK
.
7. Press
/
to highlight
Apply
and press
OK
.
8. Press
BACK
to return to
Wired LAN
page, press
/
to highlight
AMX Device Discovery
and press / to select
On
or
Off
.
9. Press
BACK
to exit the menu.
When connecting the RJ45 cable, avoid coiling and intertwining the cable as it may cause signal noise or
interruption.
If the
IP Address
still does not display, contact your ITS administrator.