Securing the projector, Utilizing the, Utilizing the password function – BenQ LH730 4000-Lumen Full HD LED DLP Projector User Manual
Page 24: Setting a password, If you forget the password, Entering the password recall procedure
24 Operation
Likewise, when you wish to switch from the
Advanced
OSD menu to the
Basic
OSD menu,
follow the instructions below:
1. Go to
System
>
Menu Settings
>
Menu Type
and press
OK
.
2. Press / to select
Basic
. Your projector will switch to the
Basic
OSD menu.
Securing the projector
Utilizing the password function
Setting a password
1. Go to
Advanced
menu -
System
>
Security Settings
>
Password
. Press
OK
. The
Password
page appears.
2. Highlight
Change Password
and press
OK
.
3. The four arrow keys ( ,
,
,
) respectively
represent 4 digits (1, 2, 3, 4). According to the
password you desire to set, press the arrow keys to
enter six digits for the password.
4. Confirm the new password by re-entering the new
password.
5. To activate the
Power On Lock
function, go to
System
>
Security Settings
>
Password
>
Power On
Lock
, press
OK
and / to select
On
. Input the
password again.
If you forget the password
If you enter the wrong password, the password error
message will appear, and the
Input Password
message
follows. If you absolutely do not remember the
password, you can use the password recall procedure.
See
Entering the password recall procedure on page 24
.
If you enter an incorrect password 5 times in succession,
the projector will automatically shut down in a short
time.
Entering the password recall procedure
1. Press and hold
OK
for 3 seconds. The projector will
display a coded number on the screen.
2. Write down the number and turn off your projector.
3. Seek help from the local BenQ service center to
decode the number. You may be required to provide
proof of purchase documentation to verify that you
are an authorized user of the projector.
• The digits being input will display as asterisks on-screen. Make a note of your selected password and
keep it in a safe place in advance or right after the password is entered so that it is available to you
should you ever forget it.
• Once a password has been set and the
Power On Lock
is activated, the projector cannot be used unless
the correct password is entered every time the projector is started.
Input New Password
Return
Password Error
Please try again.
Please write down the recall code, and
contact BenQ Customer Center.
Recall Code:
CJ-2014-541638
Recall Password
Return