Christie Access Series II UHD752-L 75" UHD 4K Commercial Monitor User Manual

Page 34

Display panel menu contents

Access II Series LCD Panel User Guide
020-001836-01 Rev.1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.

USB Option

Set to Off to disable the USB ports on the Display. Set this option as

5V to provide 5 volts power over USB. In this case, it is not available

to browse the USB content using the Media Browser feature of the

display.

Safely Remove

Use this option to remove the devices connected to the USB inputs of

the Display safely. Highlight this option and press

. Wait for the

message to be displayed on the screen indicating you can remove your

device and then remove your device. Failure to do so, may cause

problems when connecting the your USB device to other devices and

you may have to format your USB device.

Video wall settings

Press OK to open the Video Wall Settings menu screen. Video Wall

Settings, Row Count, Column Count, Cell, and Offset options are

available.

Video Wall Settings: Enable or disable the Video Wall function by

pressing Left/Right directional buttons.

Row count: Adjust the number of Video Wall rows by pressing

Left/Right directional buttons. The maximum number that can

be set is 10.

Column count: Adjust the number of VideoWall columns by pressing

Left/Right directional buttons. The maximum number that can be

set is 10.
Cell: Each Video Wall unit is called Cell. Adjust the number of a cell by

pressing Left/Right directional buttons. The maximum number that

can be set is 100. To disable video wall function of the unit and

display the image in full-screen mode, the Cell option should

be set as 0.
Offset: Offset setting is used to adjust the refractions at the sides of

the picture depending on the bezel thickness between Video Wall units

(Cells). The maximum number that can be set is 50.

For example; For a 2x3 video wall matrix, Row count option should be

set as 2 and Column count option should be set as 3. Numbers of the

cells in a video wall matrix are determined as shown in the template

below. If setting the display, which is positioned same as the display

with the number 1 in this template, then the Cell option should be set

as 1 for this display.