Christie Access Series II UHD752-L 75" UHD 4K Commercial Monitor - Manual (Page 32)

Access II Series LCD Panel User Guide
020-001836-01 Rev.1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved. 32
Display panel menu contents
No Signal Power Off
When enabled the display turns itself off after a period of five minutes,
if no signal is received from the selected source.
This feature only works if all of the following circumstances occur:
- No Signal option is set as Failover.
- USB device is not connected to the Display / USB device is connected
but there are no playable files installed on the USB device.
- - If the No Signal option is set as Input Search, this option is not
available.
Panel Lock Set to Off to prohibit the use of the buttons on the display.
RCU Inhibit Set to On to inhibit the use of the remote. Remote control functions in
Stand-By mode independently from the setting of this option.
To turn this option off and to use the remote again, press MENU/M-1-
9-7-3 buttons on the remote consecutively. Signage menu appears.
Enter the Controls menu and set this option to Off.
UART 0 Select ASCII/HEX protocol for UART 0. Default value is ASCII. Do not
restart the display restart the Display after selection to work with the
protocols correctly. If the selection is changed, the latest selected
protocol is preserved and started when the display is booted up. Note
that ASCII/HEX selection is not working while debug logs are enabled.
If wrongly changed to HEX while debug logs are enabled, revert the
selection to ASCII and reboot the display to correct the debug logs
and the ASCII protocol behaviour. Also note that HEX protocol works
with the baud rate value 19200 for UART 0.
UART 1 Select ASCII/HEX protocol for UART 1. Default value is HEX. Do not
restart the display after selection to work with the protocols correctly. If
the selection is changed, the latest selected protocol is preserved and
started when the Display is booted up.
Note: the ASCII/HEX selection is always working as expected. It does
not matter if the debug logs are enabled or not.
Note: The HEX protocol Works with the baud rate value 9600 for
UART1
Menu Lock Block the usage of the menu button on the remote by setting this
item as All menus. When you press the menu button, enter the PIN
you have defined in the First Time Installation. Set to Off to disable
this function.
Auto Source Switch If this option is enabled the display switches to the currently active
HDMI source automatically when a device is connected to the display
through the HDMI1 or HDMI2 input socket. Set as Enabled to enable
this feature.
When the HDMI source is removed, the display switches to other active
HDMI source. If no other devices are connected to the display and the
HDMI Wake UP option for the related HDMI source is enabled the
Display switches into the standby mode.
A three second restriction exists for successive connected HDMI
sources.
The second HDMI device must be plugged in for three seconds after the
first HDMI device is plugged in.
Note: This feature applies for HDMI1 and HDMI2 input sockets only.
Refer to the General View section to see the HDMI inputs.