Christie Access Series II UHD752-L 75" UHD 4K Commercial Monitor - Manual (Page 25)

Access II Series LCD Panel User Guide
020-001836-01 Rev.1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved. 25
Playing content on the display panels
Playing media from USB
Play photos, music, and movie files stored on a USB device by connecting it to the display panel.
USB memory sticks and 2.5” and 3.5” inch external hard drives with external power supplies can
provide content to the display panel through the USB inputs of the display panel. Certain types of USB
hard drives, flash drives, and USB devices such as MP3 players may not be compatible with the display
panel. The display panel supports FAT32 and NTFS disk formatting.
The following media types are supported:
mpg , mpeg , mp4 , mkv , and avi .
If both an internal USB device and external device are inserted, the media player uses the external
device only.
USB hubs can be used with the USB inputs of the display panel. External power supplied USB hubs are
recommended. When connecting a USB hard drive, use the USB inputs of the display panel directly.
Back up the files on your storage devices before connecting them to the display panel.
Before removing the USB device, ensure files are not being read or played from the device. Failure to
do so may cause physical damage to the USB player and the USB device itself.
1. Back up the files on the storage devices before connecting them to the display panel.
2. Connect a USB hard drive or flash drive to one of the USB inputs located on the side of the
display panel.
3. On the display panel remote, press Media Browser .
4. Select the media type and press OK .
5. Navigate to the media to show on the display panel.
The Media Browser menu can only display 1000 image files stored on the connected USB
device.
6. Play the selected content.
• To play all files in the list as a loop, in their original order, start playback with the Play
button and activate .
• To play the same file continuously, start playback with the OK button and activate .
• To shuffle all files in the list once, start playback with the Play button and activate .
• To shuffle all files in the list indefinitely, start playback with the Play button and activate
and .
7. To exit the menu, on the remote, press Menu again.
Playing USB media automatically
Automatically start playing the media content on a USB device.
The content types available through the Media Browser are played in a predetermined order: photo,
video, and then audio. If photo files are in the root directory
of the USB device, the Media Browser
plays the photos in alphabetical order by file name. If no photo files exist, the USB device is checked
for video content and then audio.
If
Signage settings > Controls > No signal is set to Failover , the Media Browser Autoplay setting
is ignored and any media on the connected USB device is played.
1. On the display panel remote, press Media Browser .
2. Select Settings .