Westcott FJ80 II M Universal Touchscreen 80Ws Speedlight with Adapter for Cameras - Manual (Page 15)

Group SLP (Sleep) Mode [CLIENT]
FJ Wireless Flashes can be placed into SLP (sleep) mode from any FJ transmitter. This disables the unit’s
ability to flash while other flash groups continue operating normally.
1. Determine the Group [A-F] that the FJ Wireless Flash Device is assigned to.
2. Press the corresponding
FJ Wireless Triggers Group Selection Button or the HOST FJ80 II’s
MODE Function icon continuously until SLP (sleep) appears on the transmitter and flash next to
the Group. Note that any flash units assigned to this Group will also enter into SLP (sleep) mode.
3. Exit the SLP (sleep) mode by continually pressing the corresponding FJ Wireless Trigger s Group
Selection Button or FJ80 II’s MODE Function icon [HOST mode] until the screen displays TTL or
M .
NOTE: It’s important that the Exposure Mode type is updated from the transmitter; otherwise, the flash
unit(s) will re-enter SLP (sleep) mode when the next transmission signal is received from an FJ transmitter.
Selectable Digital Touchscreen Buttons
Top Section
● Wireless Button: Fixed; The FJ80 II will default and remain in TTL-ALL Wireless Mode
when the
CLIENT Mode is enabled.
● Channel Button (CH): [01-31]
● Group Button (GR): [A, B, C, D, E, F, G, H, I, J, L, O, P, Q, S, U]
Middle Section
● TTL Exposure: [+3.0] | M Exposure: [1.0 ~ 9.0]
Lower Section
● MODE Function Button: [Manual (M), TTL]
● ZOOM Button: [Beam Spread Range Icon]
● Modeling Lamp Button: [OFF, AUTO, 1-3]
Screen Controls
● Up Arrow
● OK Button
● Down Arrow
Full-stop Increments in Manual Mode with the FJ Wireless Trigger
Please refer to your specific FJ Wireless Trigger manual to learn how to utilize this feature.
14