Canon MT-26EX-RT Macro Twin Lite - Manual (Page 114)

114
Troubleshooting Guide
Radio Transmission Wireless Multiple Flash Photography
Set the master to < 'M > and the slave to < 'x >
(p.64).
Set the transmission channels and wireless radio IDs of the master
unit and slave unit to the same numbers (p.65, 66).
Make sure the slave unit is within the transmission range of the
master unit (p.58).
Run the transmission channel scan and set the channel with the
best reception signal (p.66).
Position the slave unit at a location with the clearest possible view of
the master unit.
Face the front side of the slave’s main body toward the master unit.
When performing autoflash photography with three firing groups A,
B, and C, do not fire with firing group C pointing toward the main
subject (p.74).
When shooting in a different flash mode set for each firing group, do
not fire with multiple firing groups set to <
a > or < / >
pointing toward the main subject (p.80).
Set the shutter speed 1 stop slower than the maximum flash sync
speed (p.62).
Remote release is not possible from a slave unit with cameras
released up to 2011 or with EOS REBEL T6/1300D or EOS REBEL
T5/1200D.
The slave unit does not fire or unexpectedly fires at full output.
Pictures are overexposed.
< k > is displayed.
Cannot remote release from a slave unit.