Sybase 15.0.2 - Manual (Page 28)

System requirements
14 Adaptive Server Enterprise
3 Perform the installation using any of the methods described in
“Installation methods” on page 27.
4 Perform the post-installation tasks as described in Chapter 3, “Post-
Installation Tasks.”
System requirements
Check to make sure your system has the required version-level, RAM, and
network-protocol requirements for Adaptive Server. See the release bulletin for
your platform the latest information about required system patches.
Table 2-1: Server system requirements
Table 2-2: Disk space requirements for HP-UX 64-bit PA RISC platforms
Table 2-3: Disk space requirements for HP-UX 64-bit Itanium platform
Table 2-4: Server system requirements
Hardware Operating system Supported protocols
HP9000/700, or HP9000/800, or 64-bit HP9000
D, K, V Series, (The PA8000 chip is required.) HP-UX 11.i running 64-bit
runtime kernel SPX or TCP
HP HP-UX 11iV2 SPX or TCP
HPIA64, Intel Architecture-64 Itanium HPUX B.11.23 SPX or TCP
Product Disk space requirements
Adaptive Server typical install 700MB
Default databases created during install 150MB
Total 1040MB
Product Disk space requirements
Adaptive Server typical install 700MB
Default databases created during install 150MB
Total 1040MB
Operating system Hardware Supported protocols
Windows 2000 Pro, Server,
Adv.Server and DataCenter
Edition SP4 or higher • Intel Pentium III 600 MHz or higher
• AMD Athlon 1 GHz or higher
• TCP
• IPX/SPX
• Named pipes (not supported for
LDAP server connections