HP Z32 31.5" 16:9 4K UHD IPS Display (Smart Buy) - Manual (Page 17)

Mounting the monitor
The monitor panel can be attached to a wall, swing arm, or other mounting fixture.
NOTE: This apparatus is intended to be supported by UL– or CSA–Listed wall-mount bracket.
CAUTION: This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a third-
party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm–long screws are required. Longer
screws may damage the monitor. It is important to verify that the manufacturer’s mounting solution is
compliant with the VESA standard and is rated to support the weight of the monitor display panel. For best
performance, use the power and video cables provided with the monitor.
Removing the monitor stand
CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and all cables are
disconnected.
1. Disconnect and remove all cables from the monitor.
2. Position the monitor face down on a flat surface covered by protective sheet foam or a nonabrasive
cloth.
3. Press the VESA release button (1) to release the stand.
4. Swing the bottom of the stand up until the mounting plate clears the recess in the panel (2).
5. Slide the stand out of the recess (3).
Setting up the monitor 11