beautypg.com

Removing the monitor stand, Attaching the monitor head to a mounting device – HP P22 G5 21.5" Monitor User Manual

Page 17

background image

Longer screws might damage the monitor. Be sure that the manufacturer’s mounting solution is compliant

with the VESA standard and is rated to support the weight of the monitor head. For best performance, use

the power and video cables provided with the monitor.

NOTE:

This apparatus is intended to be supported by a UL-listed or CSA-listed wall-mount bracket.

Removing the monitor stand

If you decide to use a wall mount instead of the monitor stand that you attached, first remove the stand.

IMPORTANT:

Before you disassemble the monitor, be sure that the monitor is turned off and all cables are

disconnected.

IMPORTANT:

To position and stabilize the monitor, HP recommends that two people perform these

procedures.

1.

Disconnect and remove all cables from the monitor.

2.

Position the monitor facedown on a flat surface covered by protective sheet made of foam or a clean, dry

cloth.

3.

Push up the latch or screw near the bottom center of the stand’s mounting plate (1).

4.

Swing the bottom of the stand up until the mounting plate clears the recess in the monitor head (2).

5.

Slide the stand out of the recess.

Attaching the monitor head to a mounting device

You might need additional tools such as a screwdriver (purchased separately) when you attach a mounting

device. To avoid damage to your monitor, follow these instructions.

Removing the monitor stand

11