Mounting the monitor head – HP P22 G5 21.5" Monitor User Manual
Page 16

2.
Position the monitor stand on the mounting plate on the rear of the monitor (1), and then tighten the
screw on the monitor stand into the mounting plate (2).
3.
Attach the base to the monitor stand (1), and then tighten the screws (2).
NOTE:
The base for your monitor may appear different than the one pictured.
Mounting the monitor head
To attach your monitor to a wall using a swing arm or other mounting fixture, follow the steps in this section
to safely and securely connect your monitor.
IMPORTANT:
This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a third-
party mounting solution to the monitor head, use four 4 mm, 0.7 pitch, and 10 mm long screws (M4 x 10L).
10
Chapter 1 Getting started
This manual is related to the following products: