Electrolux EKC6047 - Manual (Page 39)

electrolux installation
39
Installation
•
This appliance must be installed
by a qualified
electrician/competent person.
Safety may be impaired if
installation is not carried out in
accordance with these
instructions.
•
This appliance must be earthed.
•
Do not remove the screws from
the earth tab extending from the
oven mains terminal block.
•
Before connecting the appliance
make sure that the voltage of
your electricity supply is the
same as that indicated on the
rating plate. This is situated on
the lower front frame of the
appliance and can be seen upon
opening the door. Alternatively
the rating plate may also be
found on the back or top of some
models (where applicable).
•
Do not alter the electrical
circuitry of this appliance.
Things to note
•
This appliance is designed to be
fitted in cabinets of the
recommended dimensions as
shown.
•
If your cabinet interior dimension is
between 565-570mm the oven
may still be fitted. However, a
minor modification to the cabinet
will be required to reduce the
aperture size down to 560-565
mm, to allow the product to be
securely screwed into the cabinet.
•
The dimensions given provide
adequate air circulation around the
unit within the cabinet, ensuring
compliance with BS EN60-335.
•
Enquiries regarding the installation
of the cooker point, if required,
should be made to your Regional
Electricity Company to ensure
compliance with their regulations.
•
The appliance socket switch
should be outside the cabinet but
within 2m of the appliance to make
it accessible to switch off the
appliance in case of an emergency.
•
To protect the hands, wear gloves
when lifting the oven into its
housing.
Do not lift the appliance by the
handles.