Sony E 50mm f/1.8 OSS Lens (Black) - Manual (Page 8)

Location and Function of Parts and Controls
8
Location and Function of Parts and Controls
Front Panel

Speaker
The audio signal selected with the input select button is
output in stereo sound.
The outputting audio can be changed in [Audio Setting]
(page 23) of the [User Configuration] menu.
The audio signals from the speaker are output regardless
of the presence/absence of connection to the AUDIO
OUT connector on the rear (see page 11).
Audio signals will not be output when headphones are
connected to the

jack.
 
(headphones) jack
The audio signal which is selected by the input select
button is output in stereo sound.

Input select buttons
Press to monitor the signal input to each connector.
SDI1 button: to monitor the signal through the SDI
IN

connector
SDI2 button: to monitor the signal through the SDI
IN

connector
HDMI button: to monitor the signal through the
HDMI IN connector
COMPOSITE button: to monitor the signal through
the COMPOSITE IN connector

Function buttons
You can turn the assigned function on or off.
The factory setting is as follows;
F1 button: [Brightness]
F2 button: [Contrast]
F3 button: [Chroma]
F4 button: [Scan]
F5 button: [Marker]
F6 button: [Volume]
F7 button: [WFM/ALM/Vector]
You can assign various functions in [Function Button
Setting] (page 19) of the [User Configuration] menu.
The [Function Button Setting] menu can also be
displayed by pressing and holding the function button.
Press the button [Brightness], [Contrast], [Chroma],
[Volume], [WFM Line Position], [Phase], [Aperture] or
[Focus Gain] function assigned to display the
adjustment screen. Press the same button again, and the
adjustment screen disappears, but you can adjust the
value without the setting value display.

Menu operation buttons
Displays or sets the on-screen menu.
Menu selection control
When the menu is displayed, turn the control to select
a menu item or setting value, and then press the
control to confirm the setting.
If the menu is not displayed and the menu selection
control is pressed, the characters that represent the
names of the buttons light up. Also, the names of the
functions assigned to the function buttons appear on
the screen. Press again to clear it.