Sony E 50mm f/1.8 OSS Lens (Black) - Manual (Page 22)

Adjustment Using the Menus
22
[Focus Assist Setting]
[WFM/ALM/Vector (waveform monitor,
audio level meter, and vectorscope) Setting]
[Transparency] Selects [Black] or [Half] (transparent)
for the background of time code display.
 [Black]: The background becomes
black. Displayed image is hidden
behind the background.
 [Half]: The background becomes
transparent. Displayed image
appears under the time code
display.
Submenu Setting
[Focus Assist] Selects [On] to use the camera focus
and [Off] not to use.
[Focus Mode] Switches the camera focus mode.
 [Color]: Displays the intensified areas
of images with color selected in
the color setting below.
 [Color]: Selects the displayed
intensified color from among
[Red], [Green], [Blue],
[Yellow], [White].
 [Standard]: An image with
sharpened edges is displayed.
[Frequency] Sets the center frequency of the edge
sharpening signal. You can select from
among [Low], [Middle], [Middle High],
[High].
[Range] Sets the target of edge sharpening. You
can select from among [Narrow],
[Middle], [Wide].
[Gain] Sets the level of edge sharpening.
Submenu Setting
Submenu Setting
[Display] Select [On] to display the [WFM]
(waveform monitor), [ALM] (audio
level meter), or [Vector] (Vectorscope);
or [Off] not to display.
[WFM/ALM/Vector]  [WFM]: Displays the waveform
monitor.
 [ALM]: Displays the audio level
meter.
 [Vector]: Displays the vectorscope.
When [WFM] is selected, the waveform
and audio level are displayed. When
YCbCr format signal is input, the Y
signal waveform is displayed. When
RGB format signal is input, the G signal
waveform is displayed. When [ALM] is
selected, the audio level is displayed in
eight channels.
When [Vector] is selected, the color
component of the image signal and the
audio levels are displayed.
When SDI signal is input, the audio
levels for channels selected in [SDI
Audio Setting] are displayed.
Each display type is illustrated below.
(The waveform percentage and audio
level units/values do not appear on the
display.)
When [WFM] is selected
Waveform Audio level
Channel number