beautypg.com

Turntable fm radio bluetooth device – Sony a7 II Mirrorless Camera with 28-70mm Lens User Manual

Page 34

background image

34

GB

D:\NORM'S JOB\SONY HA\SO17_STR-DH190_PMRF1\STR-DH190 (PMRF

01)\4726907121_GB\080TRU.fm

masterpage: Left

STR-DH190

4-726-907-

12

(1)

There is no sound from a specific
device.

• Check that the device is correctly

connected to the corresponding audio
input jacks.

• Check that the cable(s) used for the

connection is (are) fully inserted into the
jacks on both the receiver and the device.

The left and right sound is
unbalanced or reversed.

• Check that the speakers and device are

connected correctly and securely.

• Check the speaker balance (page 28).

There is severe hum, interrupted
noise or distortion from the device
connected to the PORTABLE IN jack.

• Check that the device is connected

securely.

• This is not a malfunction and will depend

on the connected device.

Recording cannot be carried out.

• Check that the device is connected

correctly.

• Select the source device using the input

buttons (page 31).

Only a very low level of sound is
heard.

• Check that MM type cartridge is used on

the turntable.

There is severe humming.

• If your turntable has a grounding

terminal, connect grounding wire
(page 15).

There is distorted sound.

• If you connect a turntable with a PHONO/

LINE switch, make sure that the PHONO/
LINE switch on the turntable is set to
PHONO (page 16).

The FM reception is poor.

• Extend and adjust the position of the FM

wire antenna (aerial) to a place where the
reception conditions are good.

• Place the FM wire antenna (aerial) near a

window.

• Position the FM wire antenna (aerial) as

horizontally as possible.

You cannot tune to radio stations.

• Check that the antennas (aerials) are

connected securely. Adjust the antennas
(aerials) if necessary.

• No stations have been preset or the

preset stations have been cleared (when
tuning by scanning preset stations is
used). Preset the stations.

• Press DISPLAY repeatedly so that the

frequency appears on the display panel.

RDS does not work.*

• Make sure that you are tuned to an FM

RDS station.

• Select a stronger FM station.

• The station you tuned to is not

transmitting the RDS signal or the signal
strength is weak.

The RDS information that you want
does not appear.*

• The service may be temporarily out of

order. Contact the radio station and find
out whether they actually provide the
service in question.

* European and Asia-Pacific models only.

Pairing cannot be done.

• Move the BLUETOOTH device closer to

the receiver.

• Pairing may not be possible if there are

other BLUETOOTH devices near the
receiver. In this case, turn off the other
BLUETOOTH devices.

Turntable

FM radio

BLUETOOTH device