Roland AIRA Compact J-6 Chord Synthesizer User Manual
Page 20
Functions and Menus
20
Item
Value
Explanation
SYnC
(MIDI Clock Sync)
AUTO
,
InT
,
NIDI
,
USB
Sets which synchronization signal is used by this unit.
AUTO
(Auto): Inputted clocks are accepted.
InT
(Int): The unit operates according to its internal clock.
NIDI
(MIDI): Only MIDI input is accepted.
USB
(USB): Only USB MIDI input is accepted.
*
Note that when an external device is connected to the SYNC IN jack, the unit
always synchronizes to the clocks that are inputted to the SYNC IN jack.
thrv
(MIDI Thru)
OFF
,
On
Sets whether to output the messages that are input from the MIDI IN connector to the
MIDI OUT connector (ON) or not (OFF).
txPc
(TX Program Change)
OFF
,
On
Sets whether program change messages are transmitted or not when the pattern
changes.
rxPc
(RX Program Change)
OFF
,
On
Sets whether the pattern changes when a program change message is received.
Pc.Ch
(Program Change
Channel)
1
–
16
Sets the MIDI channel for transmitting/receiving the program change messages used
to change patterns.
vELo
(Key Velocity)
1
–
127
Sets the keyboard velocity.
tUnE
(Tune)
433.0
–
448.0
Sets the master tuning.
(Default value:
440.0
Hz)
USb.d
(USB Direct Out)
OFF
,
1
–
127
Configures the volume of the signal output to USB.
OFF
: Uses the VOLUME knob’s setting.
1
–
127
: Sets the volume apart from the VOLUME knob’s setting.
A.LnK
(AIRA Link) (*2)
OFF
,
On
Set this to ON when connecting a device via USB that is compatible with AIRA LINK,
such as the MX-1.
Otherwise, leave this at the OFF setting.
The setting takes effect after the unit is powered off and on again.
Cnt.I
(Count In)
OFF
,
2
–
4
Sets the length (the number of beats) of the count-in for recording.
COPY
(Copy)
Copies the current pattern to a specified pattern.
The save destination number is shown in the display.
●
Use the [TEMPO/VALUE] knob to select the save destination number.
●
Press the [D (ENTER)] button to save.
●
If you want to cancel, press the [C (EXIT)] button.
init
(Initialize Pattern)
Initializes the currently selected pattern (including the sounds).
*1: The settings are made for the currently selected pattern (and can be saved for each pattern).
*2: When using with another port besides the USB HOST 3 port on the MX-1, the unit starts up in battery-only mode. To use
battery-only mode, turn on the power while holding down the [C (EXIT)] button.