Roland ST-AX2 Dedicated Stand for AX-Edge or AX-Synth Keytar - Manual

Owner’s Manual for the AX-Edge or AX-Synth Dedicated Stand
Before using this product, carefully read this owner’s manual.
IMPORTANT NOTES
5 This product is a dedicated stand for the Roland AX-Edge or AX-Synth. Do not use this product for
other purposes.
5 Do not perform any modifications on the product.
5 Before you use this stand, make sure that the stand’s legs are opened completely.
5 Make sure you always have the product placed so it is level and sure to remain stable. Never place it
on stands that could wobble, or on inclined surfaces.
5 In households with small children, an adult should provide supervision until the child is capable of
following all the rules essential for the safe operation of the product.
5 Protect the product from strong impact. (Do not drop it!)
5 Never climb on top of, nor place heavy objects on the product.
5 When folding or assembling this stand, take care not to pinch your hand or fingers.
5 For everyday cleaning wipe the product with a soft, dry cloth or one that has been slightly
dampened with water. To remove stubborn dirt, use a cloth impregnated with a mild,
non-abrasive detergent. Afterwards, be sure to wipe the product thoroughly with a soft,
dry cloth.
5 Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration
and/or deformation.
5 Depending on the material and temperature of the surface on which you place the stand, its rubber
feet may discolor or mar the surface. You can place a piece of felt or cloth under the rubber feet to
prevent this from happening. If you do so, please make sure that the product will not slip or move
accidentally.
5 When placing the AX-Edge or AX-Synth on this stand or removing the AX-Edge or AX-Synth from
this stand, take care that the cable or strap does not become tangled.
5 This document explains the specifications of the product at the time that the document was issued.
For the latest information, refer to the Roland website.
© 2018 Roland Corporation
When using the stand, lower
the fall-prevention bar.
Placing the AX-Synth
Rubber pad
Place the AX-Synth so that its
rubber pad is between the
lower arms.
Placing the AX-Edge
Strap pin
Place the AX-Edge so that its
strap pin is between the lower
arms.
Placing the AX-Edge
Adjust the position of the
fall-prevention bar so that it
supports the lower part of the
AX-Edge as much as possible.
Placing the AX-Synth
Adjust the fall-prevention
bar so that it is between the
AX-Synth’s touch controller
and [OCTAVE/VARIATION]
button.
ST-AX2 01
English