Bluetooth power on (sound mode), Disconnecting the bluetooth device from a soundbar – Samsung Q Series HW-Q600C 360W 3.1.2-Channel Dolby Atmos Soundbar System User Manual
Page 31
ENG - 31
•
A Bluetooth device may experience noise or malfunction under in the following conditions:
– When the body is in contact with the signal transceiver on the Bluetooth device or Soundbar
– In corners or when there is an obstacle in proximity, such as a wall or partition, where electrical
changes may occur.
– When exposed to radio interferences by other products operating on the same frequency
ranges, such as medical equipment, microwave ovens, and wireless LAN devices.
– Obstacles such as doors and walls may still impact the sound quality even when the devices
are within the effective range.
•
Note that your Soundbar cannot be paired with other Bluetooth devices while using the Bluetooth
option.
•
This wireless device may cause electrical interference during operation.
Bluetooth Power On (SOUND MODE)
If a previously paired Bluetooth device tries to pair with the Soundbar when the Bluetooth Power On
function is on and the Soundbar is turned off, the Soundbar turns on automatically.
1.
Press and hold the
SOUND MODE
button for more than 5 seconds on the remote while the
Soundbar is turned on.
2.
“
ON-BLUETOOTH POWER
” appears on the Soundbar’s display.
Disconnecting the Bluetooth device from a Soundbar
You can disconnect a Bluetooth device from the Soundbar. For instructions, see the Bluetooth device’s
user manual.
•
The Soundbar will be disconnected.
•
When the Soundbar is disconnected from the Bluetooth device, the Soundbar will display
“
BT DISCONNECTED
” on the front display.
Disconnecting the Soundbar from the Bluetooth device
Press the
(Source)
button on the top panel or on the remote control, and then change to any mode
except “
BT
”.
•
Disconnecting takes time because the Bluetooth device must receive a response from the
Soundbar. (Disconnection time may differ, depending on the Bluetooth device)
•
When the Soundbar is disconnected from the Bluetooth device, the Soundbar will display
“
BT DISCONNECTED
” on the front display.