If the device fails to connect – Samsung Q Series HW-Q600C 360W 3.1.2-Channel Dolby Atmos Soundbar System User Manual
Page 30
ENG - 30
If the device fails to connect
•
If you have an existing Soundbar (e.g., “
[AV]Samsung Soundbar Q6C-Series
”) on the list of speakers
on the Mobile device, delete it.
•
Then repeat steps 1 and 2.
What is the difference between BT READY and BT PAIRING?
•
BT READY
: In this mode, you can reconnect TV or mobile device that was connected before.
•
BT PAIRING
: In this mode, you can connect a new device to the Soundbar. (Press the
PAIR
button
on the remote control or press and hold the
(Source)
button on the top of the Soundbar for
more than 5 seconds while the Soundbar is in “
BT
” mode.)
Notes on Bluetooth connection
•
Locate a new device within 3.28 ft (1 m) to connect via Bluetooth communication.
• If asked for a PIN code when connecting a Bluetooth device, enter <0000>.
•
In Bluetooth connection mode, the Bluetooth connection will be lost if the distance between the
Soundbar and the Bluetooth device exceeds 32.8 ft (10 m).
•
The Soundbar automatically turns off after 18 minutes in the Ready state.
•
The Soundbar may not perform Bluetooth search or connection correctly under the following
circumstances:
–
If there is a strong electrical field around the Soundbar.
– If several Bluetooth devices are simultaneously paired with the Soundbar.
– If the Bluetooth device is turned off, not in place, or malfunctions.
•
Electronic devices may cause radio interference. Devices that generate electromagnetic waves
must be kept away from the Soundbar main unit - e.g., microwaves, wireless LAN devices, etc.
• The Soundbar supports SBC data (44.1kHz, 48kHz).
•
Connect only to a Bluetooth device that supports the A2DP (AV) function.
•
You cannot connect the Soundbar to a Bluetooth device that supports only the HF (Hands Free)
function.
•
Once you have paired the Soundbar to a Bluetooth device, selecting “
[AV]Samsung Soundbar
Q6C-Series
” from the device’s scanned devices list will automatically change the Soundbar to “
BT
”
mode.
– Available only if the Soundbar is listed among the Bluetooth device’s paired devices.
(The Bluetooth device and the Soundbar must have been previously paired at least once.)
•
The Soundbar will appear in the Bluetooth device’s searched devices list only when the Soundbar is
displaying “
BT READY
”.
•
When connecting the Soundbar to a Bluetooth device, place them as close to each other as possible.
•
The farther the Soundbar and Bluetooth device are from each other, the lower the sound quality
will become. The Bluetooth connection may disconnect when the devices are out of the effective
range.
•
The Bluetooth connection may not function as intended in areas with poor reception.