Samsung Q Series HW-Q600C 360W 3.1.2-Channel Dolby Atmos Soundbar System - Manual (Page 27)

ENG - 27
NOTES
• When you use Dolby Atmos®/DTS:X : If the input source is Dolby Atmos®/DTS:X, refer to “Output
specifications for the different sound effect modes” on page 14 .
• When Dolby Atmos® is activated, “ DOLBY ATMOS ” appears in the front display.
• When DTS:X is activated, “ DTS:X ” appears in the front display.
• Configuring Dolby Atmos®/DTS:X on your BD player or other device.
Open the audio output options on the settings menu of your BD player or other device and make
sure that “No Encoding” is selected for Bitstream. For example, on a Samsung BD Player, go to
Home Menu → Sound → Digital Output and then select Bitstream (unprocessed).
• HDMI Pass-Through is that the Soundbar plays the audio from the source through its own speakers
and sends the unaltered video signal to a TV via the second HDMI cable.
Supported UHD Signals Specification (3840 x 2160p)
Frame rate (fps) Color depth RGB 4:4:4 YCbCr 4:4:4 YCbCr 4:2:2 YCbCr 4:2:0
< 60
8 bit O O O O
10 bit - - O O
12 bit - - O O
120
8 bit - - - -
10 bit - - - -
• Supported specification may vary depending on the connected external device or usage conditions.
Method 2. Connecting using an Optical Cable
OPTICAL OUT
HDMI TO TV
(ARC)
DIGITAL AUDIO IN (OPTICAL)
Optical Cable
(not supplied)
Bottom of the Soundbar
BD / DVD player /
Set-top box /
Game console
D.IN
Top of the Soundbar
1. Connect the DIGITAL AUDIO IN (OPTICAL) port on the Soundbar and the OPTICAL OUT port on the
external device with the optical cable (not supplied), as shown in the figure.
2. Select “ D.IN ” mode by pressing the (Source) button on the top panel or on the remote control.
3. The external device sound is output from the Soundbar.