MIDEA 10,000 BTU U-shaped - Manual (Page 9)


Page 9

NOTICE
The cool circuit has an auto m atic 3 m inutes ti m e delayed start if the unit is turned off and on
quickly. This prevents overheating of the co m pressor and possible circuit breaker tripping.
Air Conditioner Operation
WARNING
To reduce the risk of fire, electrical shock, or injury to people or property, read the
SAFETY PRECAUTIONS before operating this appliance.
To begin operating the air conditioner, follow these steps:
1. Plug in the air conditioner (be sure to follow the power cord instructions on Page 6).
2. Turn the power on to the air conditioner, using the ON/OFF button.
3. Set the thermostat to the coldest temperature setting.
4. Select the Cool mode setting.
5. Adjust the louver for comfortable air flow (see Air Directional Louvers).
6. Once the room has cooled, adjust the thermostat to the setting you find most comfortable.
7. Make sure the air flow inside and outside is not obstructed by anything.
Cooling Operation
Outdoor temp.: 64°F ~ 109°F / 18°C ~ 43°C
(64°F ~ 125°F / 18°C ~ 52°C for special tropical models)
Indoor temp.: 60°F ~ 90°F / 16°C ~ 32°C
NOTICE
• The relative hu m idity of roo m should be less than 80%. If the unit is used in a condition with
a relative hu m idity over 80%, there will be condensed water on the surface of the unit.
• Perfor m ance m ay be reduced outside of these operating te m peratures.
Oper
ating
Ins
tructions
Air Directional Louvers
The louvers will allow you to direct the air
flow up or down (on some models) and left
or right throughout the room as needed.
Pivot horizontal louvers until the desired
up/down direction is obtained.
Move the louvers from side to side until the
desired left/right direction is obtained.
Air Direction
Lever
Lever
Lever
Air Direction