MIDEA 10,000 BTU U-shaped - Manual (Page 11)


Page 11

Oper
ating
Ins
tructions
4. (EC0) Button
Press ECO button to initiate this function.
This function is available on COOL, DRY,
and AUTO (only AUTO-COOLING and
AUTO-FAN) modes. The fan will continue
to run for 3 minutes after the compressor
shuts off.
The fan then cycles on for 2 minutes
at 10 minute intervals until the room
temperature is above the set temperature,
at which time the compressor turns back
on and Cooling Starts.
5. (MODE) Button
• To choose operating mode, press
MODE button. Each time you press
the button, a mode is selected in a
sequence that goes from Auto, Cool,
Dry and Fan. The indicator light beside
the button will be illuminated and
remain on once that mode is selected.
• The unit will automatically initiate the
Energy Saver function under Cool,
Dry, and Auto (only Auto-Cooling and
Auto-Fan) modes.
To operate on AUTO feature:
• When you set the air conditioner to
AUTO mode, it will automatically
select cooling or fan only operation,
depending on what temperature you
have selected and the current room
temperature.
• The air conditioner will control room
temperature automatically according
based on the temperature you’ve set.
• In this mode, the fan speed cannot
be adjusted, it starts automatically
at a speed according to the room
temperature.
To operate on COOL m ode:
• Choose Cool Mode to set the cooling
function. Use the UP ( ) or DOWN
( ) buttons to choose the desired
temperature. When Cool Mode is
selected, the fan speed can be adjusted
by pressing the FAN button.
To operate on DRY m ode:
• In this mode, the air conditioner will
generally operate as a dehumidifier.
Since the conditioned space is a closed
or sealed area, some degree of cooling
will continue. On Dry mode, the fan
speed is not adjustable.
To operate on FAN m ode:
• Use this function only when cooling
is not desired, such as for room air
circulation or to exhaust stale air (on
some models). (Remember to open
the vent during this function, but keep
it closed during cooling for maximum
cooling efficiency.) You can choose any
fan speed you prefer.
• In Fan Only mode, the temperature can
not be adjusted.
6. (UP/DOWN) Button
Press UP ( ) or DOWN ( ) button to
change temperature setting.
7. (FAN SPEED) Button
Press FAN button to select the Fan Speed
in four steps - Auto, Low, Med or High.
Each time the button is pressed, the fan
speed mode is shifted.
8. (SLEEP) Button
Press SLEEP button to initiate the
sleep mode. In this mode the selected
temperature will increase (in cooling
mode) by 2°F/1 (or 2)°C 30 minutes after
the mode is selected. The temperature
will then increase (in cooling mode) by
another 2°F/1(or 2)°C after an additional
30 minutes.
This new temperature will be maintained
for 7 hours before it returns to the
originally selected temperature.
This ends the Sleep mode and the unit
will continue to operate as originally
programmed. The Sleep mode program can
be cancelled at any time during operation
by pressing the SLEEP button again.