MIDEA 10,000 BTU U-shaped - Manual (Page 14)


Page 14

Ins
tallation
Ins
tructions
WARNING - Before You Begin
Read these instructions co m pletely
and carefully.
• IMPORTANT - Save these instructions.
• IMPORTANT - Observe all governing
codes and ordinances.
We reco mm end that two people
install this product.
Proper installation is the responsibility
of the installer.
Product failure due to i m proper
installation is not covered under the
Li
m ited Warranty.
You MUST use all supplied parts and
use proper installation procedures as
described in these instructions when
installing this air conditioner.
Do not, under any circu m stances, cut
or re m ove the third (ground) prong
fro m the power cord.
Do not change the plug on the power
cord of the air conditioner.
Alu m inu m house wiring m ay present
special proble m s - consult a qualified
electrician.
When handling unit, be careful to
avoid cuts fro
m sharp m etal edges and
alu m inu m fins on front and rear coils.
Please wear cut-resistant gloves.
Tools You Will Need
WINDOW REQUIREMENTS
Your air conditioner is designed
to install in standard double hung
windows with opening widths of 22
to 36 inches (558
mm to 914 mm ) and
a window height of 13.75” (349 mm ).
Wooden Windows
INNER
WINDOW SILL
INTERIOR
WALL
13.75" min
(349 mm)
22" to 36"
(558 mm to 914mm)
SEAL FOAM
Vinyl-Clad Windows
INNER
WINDOW SILL
13.75" min
(349 mm)
22" to 36"
(558 mm to 914mm)
SEAL FOAM
Flathead
Screwdriver
Pencil
Ruler or tape m easure
Scissors or knife
Drill and 1/8” drill bit
Phillips
Screwdriver
Level
Proper PPE
NOTICE
You will probably want to clean both
sides of the glass first. If the window
is a triple-track type with a screen
panel included, re
m ove the screen
co m pletely before installation.