MIDEA 10,000 BTU U-shaped - Manual (Page 15)


Page 15

Ins
tallation
Ins
tructions
Lower sash must open sufficiently to allow a clear vertical opening of 13.5 inches. Side
louvers and the rear of the AC must have clear air space to allow enough airflow through
the condenser for heat removal. The rear of the unit must be outdoors, not inside a
building or garage.
Remove the air conditioner and hardware from the carton and place on a flat surface.
1. INSTALL THE SUPPORT BRACKET
NOTICE
Save carton and these Installation Instructions for future reference. The carton is the best
way to store unit during winter, or when not in use.
NOTICE
If any piece of hardware is m issing, DO
NOT INSTALL THE PRODUCT, and call
custo
m er service at 1-866-646-4332.
Angled Support
Arms
Right
Extension
Arm
Left Extension
Arm
Spring Push Pin
Main Support
Rear Cross
Brace
Horizontal Bracket
Required Installation Hardware Optional Installation Hardware
Side Arm Foam 2
Right Extension Arm – Short
(For 22”-26” windows)
1
Cotter Pin 2
Open Window Bracket – LH 1
Open Window Bracket – RH 1
Main Support Pin 2
Right Extension Arm
(For 26”-36” windows)
1
1 Main Bracket
1/2” Type B Screw 2
1/4” Type B Screw 2
1/2” Type A Screw 3
Window Sash Lock
Thick Window Sash Seal Foam
Thin Window Sash Seal Foam
Miscellaneous Sealing Foam
Additional Side Arm Foam
1” Type A Screw 2
2
1
1
1
1
WARNING
Bracket should only be used for its intended purpose. If not, the warranty will be voided.