MIDEA 10,000 BTU U-shaped - Manual (Page 16)


Page 16

NOTICE
The Angled Support Ar m s should
co m e installed into the Main Supports
fro m the factory.
The s m all tabs on the sides of the
Angle Support Ar m s m ust sit on the
inside botto m of the Main Support.
On a flat surface such as a table,
press the spring push pin and adjust
the Left Extension Arm to the Left
side of the Horizontal Bracket.
Then install the Right Extension Arm
into the Right side of the Horizontal
Bracket. These will be adjusted in a
later step.
For windows where the front of the
bracket to sit on the window sill,
adjust the extension arms to your
window sill width. For windows
where the front of the bracket will
rest against the vinyl lip, these arms
will be adjusted in a later step.
A. Before placing the bracket in the
window, allow the Angled Support Arms
to rotate down and make sure they
don’t fall out of the Main support arms.
Place the support bracket assembly in
your window opening on the bottom
windowsill. The Horizontal Bracket and
Extension Arms must be located on the
indoor side of your window frame.
For installations where the bracket sits
on the window sill, secure the bracket
to the window (reference Step E).
Spring Push Pin
Horizontal Bracket
Right
Extension
Arm
Left
Extension
Arm
WARNING
Maintain control of the bracket until
installation is co
m plete.
Window Frame
Ins
tallation
Ins
tructions