Menu items, Nschedule – Sharp PN-U423 User Manual
Page 27
27
E
Menu Items
Caution
• Do not switch off the main power after setting the
SCHEDULE.
• Specify the correct date and time. (See page 23.)
SCHEDULE does not function unless the date and time are
specified.
• Check regularly that the set date and time are correct.
TIPS
• Up to 7 SCHEDULE items can be registered.
• Setting the SCHEDULE flashes the power LED alternately
in red and orange in standby mode.
• A SCHEDULE that has a large number has precedence
over that of a small number when schedules overlap.
• In the following cases, set separate power-on SCHEDULE
and power-off SCHEDULE:
- The power is turned off and then on, in that order, in the
SCHEDULE
- The power is turned on and then off, in that order, in the
SCHEDULE, but the power-off time is the next day or later
n
SCHEDULE
You can set the time to switch the monitor on and off.
Set this function with SCHEDULE in the SETUP menu. (See
page 23.)
(1)
(5)
(2)
(3)
(4)
BACK···[RETURN]
V: 60 Hz H: 67.5 kHz
– : –
– : –
–
D-SUB
SCHEDULE
ON
EVERY DAY
WED
SAT
OFF
INPUT
XXXX / XX / XX XX XX : XX : XX
MON
THU
SUN
TUE
FRI
EVERY WEEK
1 9 2 0 x1 0 8 0
1. Press
or
to select the SCHEDULE number, and
press
.
2. Set the SCHEDULE. ((2) to (5) below)
Press
or
to select items.
3. Press
RETURN
.
4. Press
or
to select the SCHEDULE number, and
press
ENTER
. ((1) below)
SCHEDULE becomes effective.
(1) SCHEDULE number
Enable/disable the SCHEDULE with
ENTER
.
■: SCHEDULE effective
□: SCHEDULE not effective
(2) ON
Specify the time the power turns on with
or
.
Set the time on a 24-hour basis.
(3) OFF
Specify the time the power turns off with
or
.
Specify a time later than the time the power is turned on.
Set the time on a 24-hour basis.
(4) INPUT
Specify the input mode at power on with
or
. If you
don’t specify this the input active at the last power-off will
appear.
(5) Day of the week
Specifies the day of the week to execute the SCHEDULE
with
ENTER
.
• EVERY DAY
Executes the SCHEDULE every day regardless of the day
of the week.
• MON - SUN
Executes the SCHEDULE once on the specified day.
• EVERY WEEK
Executes the SCHEDULE on the specified day every
week.
Select EVERY WEEK and specify the day of the week
(MON - SUN).