Sharp PN-U423 - Manual (Page 25)

25
E
Menu Items
n OTHERS
SCREEN MOTION
Residual images can be reduced by moving the entire screen vertically and horizontally.
Set the time (operating interval) until the screen moves.
POWER MANAGEMENT
POWER MANAGEMENT determines whether or not to switch modes from no signal to the input signal standby mode.
When the input mode is DisplayPort, HDMI, DVI-D, or D-SUB, or when the input mode is COMPONENT or VIDEO, the settings
of each can be configured.
LOGO SCREEN
Sets whether or not to display the logo screen.
SCAN MODE (HDMI)
Sets the scan mode.
OVERSCAN ....... Over-scan display
UNDERSCAN .....Under-scan display
BACKLIGHT OFF
When set to ON, the backlight turns off. While the backlight is off, residual images are reduced by internal display of a residual
image reduction pattern. BACKLIGHT OFF is canceled when any operation is performed, such as using the remote control unit.
COLOR SYSTEM (VIDEO)
Select the color system of the AV equipment which is connected to video input terminal. (AUTO / PAL / PAL-60 / SECAM /
NTSC3.58 / NTSC4.43)
When AUTO is selected, the color system is automatically set according to the input signal.
TIPS
• If COLOR MODE is set to sRGB, the following items cannot be set.
WHITE BALANCE, PRESET, USER, GAMMA, BLACK LEVEL and CONTRAST
• When the COLOR MODE is set to HIGH ILLUMINANCE, GAMMA can not be adjusted.
• When the SCREEN MOTION function is set to used, the SIZE is WIDE.
• When dual-screen display is selected or Enlarge is used, the SCREEN MOTION function is disabled.
• With some parameters, the same adjustment value may continue.
This is because adjustment in 100 or more steps is possible internally, and is not a failure.