Canon EOS 80D - Manual (Page 131)

129
i Selecting the Drive Mode
 o : The maximum continuous shooting speed of approx. 7.0 shots/sec.
is attained under the following conditions*: 1/500 sec. or faster shutter
speed, maximum aperture (varies depending on the lens), Anti-flicker
shooting set to Disable, with a fully-charged Battery Pack LP-E6N, and at
room temperature (23°C/73°F). The continuous shooting speed may
become slower depending on the shutter speed, aperture, subject
conditions, brightness, lens, flash use, temperature, battery type,
remaining battery level, etc.
* With the AF mode set to One-Shot AF and the Image Stabilizer turned off
when using the following lenses: EF300mm f/4L IS USM, EF28-135mm f/3.5-
5.6 IS USM, EF75-300mm f/4-5.6 IS USM, EF100-400mm f/4.5-5.6L IS
USM.
 If or is set, the time lag from when you press the shutter
button completely until the picture is taken will be slightly longer than
normal.
 With Live View shooting, and cannot be set.
 The continuous shooting speed may become slower if the remaining
battery level is low or if you shoot under low-light conditions.
 In AI Servo AF operation, the continuous shooting speed may become
slightly slower depending on the subject and the lens used.
 If you use Battery Grip BG-E14 (sold separately) with AA/R6 batteries,
the high-speed continuous shooting speed may be slower.
 If you set [z4: Anti-flicker shoot.] to [Enable] (p.152) and shoot under
a flickering light source, the continuous shooting speed may decrease
slightly, the shooting interval may become irregular, or the release time
lag may become longer.
 When internal memory becomes full during continuous shooting, the
continuous shooting speed may drop since shooting will be temporarily
disabled.