Enterasys Networks X-Pedition 2000 User Manual
Page 80
64
Enterasys X-Pedition 2000 Getting Started Guide
You are unable to access the configuration
commands in the CLI.
From the CLI, type enable to access Enable mode,
then type configure to access Configure mode.
Configuration changes do not seem to be
taking effect.
Use the procedure in Activating the Configuration
Commands in the Scratchpad
to
activate the changes.
Configuration changes are not reinstated
after a reboot.
Use the procedure in Saving the Active
Configuration to the Startup Configuration File
to save the configuration changes to the
Startup configuration file.
The XP-2000 is not resolving DNS
names.
Use the procedure in Setting the DNS Domain
Name and Address
If you have already performed this procedure,
make sure you can use NS lookup on the DNS
server to get the default domain.
An SNMP manager cannot access the XP-
2000.
Use the procedure in Setting Up SNMP Community
Strings
to set up an SNMP community
string and specify a target for SNMP traps.
If you have already performed this procedure, type
snmp show all in the CLI to check the SNMP
settings.
Use the traceroute and ping commands to verify
that the XP-2000 can reach the SNMP
management station.
You are unable to ping a certain host.
Create and add an IP or IPX interface for the host.
See the The TeraLink 2000 Series Library: User
Reference for information.
If you experience this difficulty
Try this remedy