ProSoft Technology RLXIB-IHA-A - Manual (Page 23)

RLXIB-IHA ♦ 802.11a Start Here
RadioLinx® 802.11a Industrial Hotspot User Manual
ProSoft Technology, Inc. Page 23 of 123
July 25, 2013
 WPA phrase: To use WPA encryption on packets sent between the radios,
select WPA in the Encryption Type field. Next, in the WPA phrase field, enter
a pass phrase of between eight and 63 normal keyboard characters. This
phrase automatically generates an encryption key of 128 hexadecimal
characters. The default pass phrase is "passphrase" (lower case, no quotes).
For more information on encryption, see Security settings (page 59).
Because you must assign the same Network SSID and WPA phrase to the
repeater radios later in this procedure, you should write down the settings.
Note: Network SSID and WPA phrase are both case-sensitive.
Network SSID:_________________
WPA phrase:__________________
Radio Access Settings
If a DHCP (Dynamic Host Control Protocol) server is configured on your local
area network, the DHCP server can assign IP addresses automatically.
If you prefer to assign a Static (Fixed) IP address, select "Use the following IP
address", and then enter the IP Address, Subnet Mask and Default Gateway in
the Radio Access Settings area of the IH Radio web configuration form.
Important: If you intend to assign IP addresses manually, you must not duplicate an IP address
that is already in use on your network. If you are not sure what IP addresses are available, ask
your network administrator for assistance.
1.7.6 Save the Radio Configuration
Before closing the Radio Configuration window, you must apply your changes.
Click A
PPLY C HANGES to save your configuration and restart the radio.