ProSoft Technology AN-X-AMX - Manual (Page 35)

AN-X-AMXRIO Page 31
In the IP Address field, enter the Ethernet IP address of the AN-X you wish to select. It
can be found using the Locate All AN-X Modules command. The format is as shown
above, four decimal numbers each in the range 0 to 255.
Both MAC address and IP address must match the settings on the AN-X in order for
communication to occur.
Click OK to select the AN-X.
The title bar of AnxInit shows the MAC Address and IP Address of the currently selected
AN-X.
Set AN-X IP Configuration
Utilities/AN-X IP Configuration sets the AN-X IP address and hostname.
The AN-X must be on the local Ethernet to set its IP address.
First select the AN-X using the Utilities/Select An AN-X command.
Next select Utilities/AN-X IP Configuration. The AN-X TCP/IP Configuration dialog
appears.
Enter a Host Name for the AN-X. This name is used internally by AN-X and may be
used to identify the AN-X if you have a DNS server on your network. The name can be
from 1 to 31 characters long.
To configure the AN-X to obtain its IP address from a DHCP server on the network,
select Obtain an IP address automatically (DHCP)
To configure the AN-X to use a static IP address, select Use the following Settings and
enter the following:
• the desired IP address for the AN-X.