ProSoft Technology 5201-DFNT-BACNET - Manual (Page 36)

Client Error/Status Data BACnet ♦ ProLinx Gateway
Protocol Manual BACnet/IP Client Edition 2
Page 36 of 52 ProSoft Technology, Inc.
November 24, 2010
4.1 Client Error/Status Data
The Client connection Error and Status Data areas are discussed in this section
The error/status data table is located at a virtual address assigned by ProLinx. If
this data is moved to the gateway's database using the gateway's data mapping
feature, it will be available to the other protocol supported on the gateway. If it is
not mapped into the gateway's database, the data will only be available through
the Configuration/Debug Port.
The data area is initialized with zeros whenever the module is initialized. This
occurs during a cold-start (power-on), reset (reset push-button pressed) or a
warm-boot operation (commanded or loading of new configuration).
Note: The ProLinx Reference Guide contains detailed information on accessing the contents of the
following registers.
4.1.1 BACnet Client 0 Status
The following table lists the data areas that can be mapped from the virtual
addresses into the gateway's internal database.
Status Register Description
12300 Command Request Count
12301 Command Response Count
12302 Command Error Count
12303 Number of Request Packets
12304 Number of Response Packets
12305 Errors Sent
12306 Errors Received
12307 Configuration Error Word
12308 Current Error
12309 Last Error
12310 to 12409 Command List Errors (1 word register for each command)
12410 to 12499 No Valid Data