ProSoft Technology 5201-DFNT-BACNET - Manual (Page 10)

Start Here BACnet ♦ ProLinx Gateway
Protocol Manual BACnet/IP Client Edition 2
Page 10 of 52 ProSoft Technology, Inc.
November 24, 2010
1.3 Setting Port 0 Configuration Jumpers
Before installing the module on the DIN-rail, you must set the jumpers for the
Port 0 application port.
Note: Ethernet-only ProLinx modules do not use the serial port jumper settings. The serial
configuration jumper settings on an Ethernet-only module have no effect.
Note: The presence of Port 0 depends on the specific combination of protocols in your ProLinx
module. If your module does not have a Port 0, the following jumper settings do not apply.
Port 0 is preconfigured for RS-232. You can move the port configuration jumper
on the back of the module to select RS-485 or RS-422.
Note: Some ProLinx modules do not correctly report the position of the port 0 jumper to the Port
Configuration page on the Config/Debug menu. In cases where the reported configuration differs
from the known jumper configuration, the physical configuration of the jumper is correct.
The following illustration shows the jumper positions for Port 0:
ProLinx 5000/6000 Series Module