ProSoft Technology 5202-DFNT-GRCM4 - Manual (Page 18)

START
# 1 50 0 10 0 192.168.0.101 -1 101 7 0 -1
END
#------------------------------------------------------------------------------
-
# This section is used to define the configuration for the GRCM master device
# simulated on Port 0.
#
[GRCM Port 0]
Enabled : Yes #Y=Use port, N=Do not use port
Baud Rate : 9600 #Baud rate for port 300-57600
Parity : None #N=None,O=Odd,E=Even,M=Mark,S=Space
Data Bits : 8 #5, 6, 7 or 8
Stop Bits : 1 #1 or 2
Min Response Delay : 0 #0-65535 mSec before sending response msg
RTS On : 0 #0-65536 mSec before message
RTS Off : 0 #0-65536 mSec after message
Use CTS Line : No #Use CTS modem control line (Y/N)
Response Timeout : 1000 #Response messgage timeout (0-65535 mSec)
Retry Count : 0 #Response failure retry count
Minimum Command Delay : 10 #Minimum number of msec's between commands
Error Delay Counter : 0 #0-65535 Command cycle count if error
Send With ID : Y #Send command with machine number (only work
with RS485)
Display Article Range : 2 #1=1-10, 2=11-20, 3=21-30, ... , and 10=91-
100
#------------------------------------------------------------------------------
-
# This section is used to define the configuration for the GRCM master device
# simulated on Port 1.
#
[GRCM Port 1]
Enabled : Yes #Y=Use port, N=Do not use port
RS Interface : 0 #0=RS-232, 1=RS-485, 2=RS-422
Baud Rate : 9600 #Baud rate for port 300-57600
Parity : None #N=None,O=Odd,E=Even,M=Mark,S=Space
Data Bits : 8 #5, 6, 7 or 8
Stop Bits : 1 #1 or 2
Min Response Delay : 0 #0-65535 mSec before sending response msg
RTS On : 0 #0-65536 mSec before message
RTS Off : 0 #0-65536 mSec after message
Use CTS Line : No #Use CTS modem control line (Y/N)
Response Timeout : 1000 #Response messgage timeout (0-65535 mSec)
Retry Count : 0 #Response failure retry count
Minimum Command Delay : 10 #Minimum number of msec's between commands
Error Delay Counter : 0 #0-65535 Command cycle count if error
Send With ID : Y #Send command with machine number (only work
with RS485)
Display Article Range : 2 #1=1-10, 2=11-20, 3=21-30, ... , and 10=91-
100
#------------------------------------------------------------------------------
-
# This section is used to define the configuration for the GRCM master device
ProLinx Communication Gateways, Inc. 18
06.PLNX.GRCM.OO.01.EN
July 2003
# simulated on Port 2.