ProSoft Technology AN-X-TI - Manual (Page 47)

AN-X-TI-MAS Page 43
Selecting an AN-X
Before you can perform an operation on an AN-X, you must select which
AN-X you want the operation performed on. Choose Utilities/Select An
AN-X
to select a specific AN-X.
From the Adapter list, select the network adapter that connects to the
Ethernet network that contains the AN-X.
In the Ethernet MAC Address field, enter the MAC Address of the AN-X
you wish to select. It can be found on the AN-X label or by using the
Locate All AN-X Modules
command. The format is as shown above, six
pairs of hexadecimal digits separated by hyphens.
In the IP Address field, enter the Ethernet IP address of the AN-X. It can
be found using the Locate All AN-X Modules command. The format is as
shown above, four decimal numbers, each in the range 0 to 255.