ProSoft Technology AN-X-TI - Manual (Page 23)

AN-X-TI-MAS Page 19
Network Configuration
Before you can scan a TI remote I/O network, you must configure the
network in the AN-X-TI-MAS.
There are two methods of configuring the remote I/O that the
AN-X-TI-MAS is to scan:
• autoconfiguration. The AN-X-TI-MAS reads the network contents
by sending messages to bases on the attached network.
• manual configuration. You build a configuration file and send it to
the AN-X-TI-MAS.
You can also use autoconfiguration to build an initial configuration file,
edit the file to add or change features, then perform a manual
configuration with the modified file.
Autoconfiguration
Before you can perform an autoconfiguration, the remote I/O network
must be connected to the AN-X.
From the AN-X web interface, select Automation Network/TI I/O
Network Configuration
.