ProSoft Technology MVI56E-LDM - Manual (Page 3)

B Warning - Explosion Hazard - When in Hazardous Locations, turn off power before replacing or rewiring
modules.
Warning - Explosion Hazard - Do not disconnect equipment unless power has been switched off or the area is
known to be nonhazardous.
C Suitable for use in Class I, Division 2 Groups A, B, C and D Hazardous Locations or Non-Hazardous Locations.
ATEX Warnings and Conditions of Safe Usage:
Power, Input, and Output (I/O) wiring must be in accordance with the authority having jurisdiction
A Warning - Explosion Hazard - When in hazardous locations, turn off power before replacing or wiring modules.
B *Warning - Explosion Hazard - Do not disconnect equipment unless power has been switched off or the area is
known to be non-hazardous.
C These products are intended to be mounted in an IP54 enclosure. The devices shall provide external means to
prevent the rated voltage being exceeded by transient disturbances of more than 40%. This device must be used
only with ATEX certified backplanes.
D DO NOT OPEN WHEN ENERGIZED.
CPU, Memory, and OS Specifications

CPU: 400MHz ARM9 G20
 Operating System: Linux (kern el 2.6.33.7)
 Linux Distribution: Debian GNU/Linux
 System Memory: 64MB SDRAM
 Flash Memory: 64MB ROM
 Compact Flash: 64MB card provided (16GB max supported)
General Specifications

Backplane Current Load: 800 mA @ 5 V DC; 3mA @ 24V DC
 Operating Temperature: 0 to 60°C (32 to 140°F)
 Storage Temperature: -40 to 85°C (-40 to 185°F)
 Shock: 30g Operational; 50g non-operational; Vibration: 5 g from 10 to 150 Hz
 Relative Humidity: 5% to 95% (non-condensing)
 LED Indicators: ERR - Application driven, APP - Application driven, OK - Application driven
 4-Character, Scrolling, Alpha-numeric LED Display: Application driven - possible uses
are: Module Version, IP, Application Port Setting, Status/Error Information
 All phase conductor sizes must be at least 1.3 mm(squared) and all earth ground
conductors must be at least 4mm(squared).
Ethernet Ports

2 Ethernet Ports
 10/100 Mbps
 RJ45 Connector,
 Link and Activity Indicators
 Auto-sensing crossover cable detection
Serial Ports

Full hardware handshaking control provides radio, modem, and multi-drop support.
 RJ45 (DB-9M with supplied adapter cable)
 Configurable RS-232 hardware handshaking
 500V Optical isolation from backplane
 RS-232, RS-422, RS-485 jumper-select, each port
 Rx (Receive) and Tx (Transmit) LEDs, each port