ProSoft Technology MVI56E-LDM - Manual (Page 25)

ControlLogix Platform ♦ "C" Programmable Preparing the MVI56E-LDM Module
Linux Application Development Module Developer's Manual
ProSoft Technology, Inc. Page 19 of 264
March 12, 2014
 Set the Speed to 115200
 Set the appropriate COM port
 Ensure that the Connection Type is set to Serial.
2. Click Open. The Putty session opens.
3. Enter your login and password:
RA56-daTM login: root
Password: password
Ethernet (Telnet)
You can communicate with the module through Ethernet Port 1 (E1) using
Telnet.
The Ethernet Port (E1) is programmed with eth0 set to IP 192.168.0.250 and a
Subnet Mask of 255.255.255.0. In order for your PC or laptop to talk to the
module, your PC or Laptop must be on the same subnet as the module. This
means that you must temporarily change the IP address and subnet mask on
your PC or laptop to match that of the module. You can then change the
module's IP address to match your needs.
1. Change the IP Address of your PC or Laptop so it matches the subnet of
the module.