beautypg.com

ProSoft Technology MVI69-GSC User Manual

Page 43

background image

MVI69-GSC ♦ CompactLogix or MicroLogix Platform

Configuring the MVI69-GSC Module

Generic ASCII Serial Communication Module

User Manual

ProSoft Technology, Inc.

Page 43 of 102

September 24, 2010

[Section]/Item

Value

Range

Description

Rx Packet Length:

0 to 4096

This parameter is used if bit 3 is set in the Type
parameter. The parameter sets the length of data

required to be received on the port before

transferring the data to the processor.

Rx Message Timeout:

0 to 65535

This parameter is used if bit 1 is set in the Type
parameter. The parameter sets the number of

milliseconds to wait after the first character is

received on the port before automatically sending

the data to the processor.

Rx Intercharacter Delay:

0 to 65535

This parameter is used if bit 2 is set in the Type
parameter. The parameter sets the number of

milliseconds to wait between each character

received on the port before sending the data to

the processor.

Rx Swap Bytes:

Yes or No

This parameter specifies if the data received

should have its bytes swapped before sending

over the backplane.

Tx Message Timeout:

0 to 65535

This parameter specifies the timeout period to
transmit a message out the port. A message must

be transmitted out the port within the specified

timeout period. Message transmission will be

aborted if the timeout is exceeded.

Tx Minimum Delay:

0 to 65535

This parameter specifies the minimum number of
milliseconds to delay before transmitting a
message out the port. This pre-send delay is

applied before the RTS on time. This may be

required when communicating with slow devices.

Tx Swap Bytes:

Yes or No

This parameter specifies if the data to be
transmitted out the port will have the bytes

swapped from the data presented across the

backplane.