6 reset button, Eset, Utton – PLANET PL-751 User Manual

Page 27

User’s Manual of PL-751

has been generated. It must now be linked to your network to adopt the new
network security key.

Step 9

Press and hold the security button on Bridge A for 1~3 seconds. The

Power lights on Bridge A starts to flash.

Step 10

Within 120 seconds after the Power light on Bridge A starts to flash,

press and hold the security button on Bridge C for 1~3 seconds then release.

Step 11

Bridge A, Bridge B and Bridge C is now networked to each other.

3.6 Reset Button

This section describes how to use Reset button, this button can be used to clear ALL
data and restore ALL settings to the factory default values.

The procedure is as follows:
Step 12

Hold the reset Button down while Power On for a few seconds.

Step 13

Release the reset button.

Step 14

All the LEDs will off, and then start again.

Step 15

PL-751 is now using the factory default values.

This manual is related to the following products:

PL-702