PLANET XRT-401D - Manual (Page 29)

24
Parameters Description
Host Address This is the IP address of the host in the Internet that will have
management/configuration access to XRT-401D from a remote site. This
means if you are at home and your home IP address has been
designated the Remote Management host IP address for this router
(located in your company office), then you are able to configure this
router from your home. If the Host Address is left 0.0.0.0 this means
anyone can access the router
’s web-based configuration from a remote
location, providing they know the password.
Click the Enabled box to enable the Remote Management function.
Note: When you want to access the web-based management from a
remote site, you must enter the router
’s WAN IP address (e.g. 10.0.0.1)
into your web-browser followed by port number 8080, e.g. 10.0.0.1:8080
(see below). You
’ll also need to know the password set in the Password
Setting screen in order to access the router ’s web-based management.
Port The port number of remote management web interface.
Enabled
Select “Enabled” to enable the remote management function.
Click <Apply> at the bottom of the screen to save the above configurations. You can now
configure other advance sections or start using the router (with the advance settings in place)