PLANET WSG-500 - Manual (Page 9)

9
1. Ensure the WSG-500 and the Cable/DSL modem are powered OFF before
commencing. Leave your Cable/DSL modem connected to its wall socket (phone
line or cable input).
2. Use Ethernet cables to connect to the LAN2 port on the front panel. Connect
the other end of the Ethernet cable to an AP or Switch. (Note: Authentication is
required for the clients to access the network via LAN2 port. The LAN port with
authentication function is referred to as Public LAN).
3. Use Ethernet cables to connect to the LAN1 port on the front panel. Connect the
other end of the Ethernet cable to a PC. (Note: Authentication is NOT required
for the clients to access the network via LAN1 port. The LAN port with authenti-
cation function is referred to as Private LAN).
4. Connect your Cable/DSL Modem to the WAN port on the front panel. Use the
cable supplied with your Cable/DSL modem. If no cable was supplied with your
modem, use a standard network cable. Please make sure the connection is
established (LED is on).
5. Connect the Power Adapter. Use only the unit provided.
6. Power ON. The PWR LED should stay on (If your network is connected, the
WAN/WLAN/LAN LED will be on, too).
7. Power on the PC that connected to the WSG-500.
Hint
1. Please consult your ISP personnel to obtain proper Internet
connection related information, and input carefully.
2. If Internet connection cannot be established, please check the
WAN LED display, inserted parameters or contact the ISP service
staff for support information.
3. Account Generator WSG-ACG5 is an optional device.
4. It is recommended that you leave IP settings on subscriber PC
as automatically assigned. By machine default configurations,
WSG-500 will act as a DHCP server, and it will assign PC the
necessary IP settings.