PLANET FRT-405N - Manual (Page 17)

User Manual of FRT-405N
17
Figure 2-3 Plug in the SFP transceiver
type or WDM pair; for example,
ceiver, use the multi-mode fiber cable, with one side being the
nsceiver, use the single-mode fiber cable, with
one side being the male duplex LC connector type.
to a device – switches with SFP installed, fiber NIC on a
LED of the SFP slot of the switch / converter. Ensure that the SFP transceiver is
s with some fiber-NICs or Media
Converters; setting the Link mode to “100 Force” is needed.
2.2.2 Removing the Module
istrator. You
of the Fiber router to disable the port in advance.
SFP module to horizontal.
4. Pull out the module gently through the handle.
Before connecting the other switches, workstation or Media Converter,
1. Make sure both sides of the SFP transceiver are with the same media
100Base-FX to 100Base-FX, 100Base-BX20-U to 100Base-BX20-D.
2. Check whether the fiber-optic cable type matches the SFP transceiver model.
 To connect to MFB-FX SFP trans
male duplex LC connector type.
 To connect to MFB-F20/F40/F60/FA20/FB20 SFP tra
Connecting the fiber cable
1. Attach the duplex LC connector on the network cable to the SFP transceiver.
2. Connect the other end of the cable
workstation or a Media Converter.
3. Check the LNK/ACT
operating correctly.
4. Check the Link mode of the SFP port if the link fails. It function
1. Please make sure there is no network activity by console or check with the network admin
can access the management interface
2. Remove the Fiber Optic Cable gently.
3. Turn the handle of the MFB module / mini GBIC