beautypg.com

PLANET VIP-1680 User Manual

Page 37

background image

37

The T.38 is a “Real Time Group 3 FAX communication over IP

network” format. That’s meaning it’s a protocol for Fax over IP.

You have to enable this function.

H.323 RRQ TTL

This command configures the number of seconds that the

gateway should be considered active by the H.323 Gatekeeper.

The gateway transmits this value in the RRQ message to the

gatekeeper.The default value is “0”.

H.323 Registration type

There are 2 choices for this setting. “Gateway” means it will act

as the VIP-GW. “Terminal” means it will act as the IP phone

terminal.

H.323 Telephone Advance Configuration

Silence Compression

If this function is enabled, when silence is occurred for a period

of time, no data will be sent across the network during this

period in order to save bandwidth.

Dial Complete Tone

Disable / Enable dialing complete tone.

Voice Codec option

The codec is used to compress the voice signal into data

packets. Each codec has different bandwidth requirement.

There are four kinds of codec, G.723, G.729AB, G.711_u and

G.711_A. The default value is G.723.

FXS Impedance

The FXS provides 600/900 OHM impedances for selection.

FXO AC Impedance

The FXO provides wild and complex ac termination

impedances for selection.

Phone (Line) in/out

volume

You can adjust the Phone (Line) in/out volume, range from -9db

to 9db.

FXO Tx/Rx Gain

You can adjust the FXO Tx/Rx Gain, range from -6db to 6db.

UK PSTN release tone

detection

When you use the Gateway to UK, you can Enable this

selection to detection release tone.

Scenario description: Flash detection and generation duration

1. PSTN Call from PSTN to Office PBX and dial the extension 102 go to gateway.

2. Call to gateway of oome by Hotline.

3. Home user needs call transfer to extension number 101.

4. Dial flash and gateway FXS detect and generate the flash to PBX in office.

Flash Detection: Let you change flash detection (milliseconds) of gateway when phone

generate flash to FXS.

Flash Generation: Let you change flash generation time (milliseconds) for PBX detection.

This manual is related to the following products: