PLANET NVR-420 - Manual (Page 63)

motion detected by the camera or a disk failure, the recorder can send
notification with the acceptable format (image/txt) to a destined event server
according to the configuration.
Configuring an FTP server
To add an FTP server,
1. Start by giving a name to the server that you are adding to the recorder.
2. Enter the host name or the IP address of the FTP server.
3. Enter the communication port of the FTP server (usually port 21).
4. Enter the user name and password of the FTP server if it’s required.
5. Check “Use Passive Mode” if it’s required or leave it unchecked to use active
mode.
6. Click “Test” to verify if all information is entered correctly and the connection
to the FTP server can be established successfully.
64
4-CH H.264 Network Video Recorder with HDMI
User’s Manual of NVR-420