PLANET NVR-1620 - Manual (Page 16)

16
Rear Panel
LEDs Status Definitions
HDD x 2
Green Solid green when the HDD is mounted
Red Solid red for disk fail
Amber
Solid amber when recording is in process
Blinking when recycling
Network
Green Solid green for activity on a 10/100Mbps network
Amber Solid amber for activity on a 1Gbps network
Status
Green
Solid green for normal operation
Blinking green when firmware upgrade is done
Red Blinking red for failed firmware upgrade through USB disk
Amber Blinking amber during firmware upgrade
Power
Green
Solid green - Normal operation
Blinking in green after pressing and holding the reset
button for 5 seconds indicating the device will enter the
restore default process. Other LEDs remain unchanged
during this state.
Red System off (power cord remains plugged in)
Amber
Fast blinking - During system initializing/starting.
Continuous blinking - When system is unable to start
properly (All other LEDs should be off when this LED is
blinking in amber)
Slow blinking - The system is shutting down. Other LEDs
go off according to the stages of the process.
Alarm
Red
Blinking in red when a system/camera event occurs.
Blinking should last 10 seconds for each event
None
Goes off if reaches the 10-second duration, or when
buzzer stop button is pressed (if buzzer is triggered)