PLANET ICA-H312 - Manual (Page 11)

2.3 Hardware Installation
2.3.1 Physical Installation
1. Connect an Ethernet cable
Connect the LAN cable on the camera to the network device (hub or switch).
NOTE: If there has an IEEE802.3af PoE switch in your network, you can connect the
camera LAN cable to this PoE switch to obtain power. The power adapter is
unnecessary when internet camera is connected to a PoE switch.
2. Check the LAN LED
The LED is defined to identify LAN connection type. When LAN port is connected, the LED
will be green.
3 Attach the power supply
Plug in power adapter and connect to power source. After power on, the camera will start to
operate.
NOTE: 1. Only use the power adapter supplied with internet camera Otherwise, the
product may be damaged.
2. The power adapter is unnecessary when internet camera is connected to a
PoE switch. Otherwise, the product may be damaged when internet camera is
connected to a PoE switch and power adapter simultaneously.
4 Attach BNC connector (option)
Connect the video BNC connector to a monitor set if necessary check camera viewing angle and
focus.
5 Attach Speaker to camera (option)
If user needs not only video stream but also audio stream, then the speaker should be attached to
camera.
11