Chapter 2. hardware installation, 1 hardware description, 1 the front panel – PLANET WPG-130N User Manual
Page 12: 2 led indications, Chapter 2, Hardware installation, Hardware description, The front panel, Led indications
PLANET 802.11n Wireless Presentation Gateway
WPG-130N
- -
12
Chapter 2. HARDWARE INSTALLATION
Please follow the instructions below to build the wireless network connection between WPG-130N, display
equipment and your computers.
2.1
Hardware Description
2.1.1 The Front Panel
The front panel provides a simple interface monitoring the wireless presentation gateway.
Figure 2-1
shows
the front panel of WPG-130N.
Front Panel
Figure 2-1 The WPG-130N Front Panel
Notice:
To Reset the WPG-130N to factory default:
1.
Press and hold the button, and then plug in the DC jack of the AC adapter to power
on WPG-130N. After 10~15 seconds, you can release the button. The WPG-130N
will back to the factory default mode.
2.
Be sure that you backup the current configuration of WPG-130N; else the entire
configuration will be erased when pressing the “RESET” button.
2.1.2 LED Indications
The front panel LED indicates instant status of system power; and helps monitor and troubleshoot when
needed. Below table show the LED indications of the Pocket Presentation Gateway.
LED
Description
Green Power
On
Red
Device initializing or system error
Off Power
Off