PLANET WNAP-6306 - Manual (Page 50)

User’s Manual of WNAP-6306
Figure 5-29 Wireless LED Thresholds
The page includes the following fields:
Object Description
LED1
The LED1 will switch on if the Signal Strength reaches the value
set in an entry field next to it. The default value is -70dBm.
LED2
The LED2 will switch on if the Signal Strength reaches the value
set in an entry field next to it. The default value is -50dBm.
LED3
The LED3 will switch on if the Signal Strength reaches the value
set in an entry field next to it. The default value is -30dBm.
LED4
The LED4 will switch on if the Signal Strength reaches the value
set in an entry field next to it. The default value is -10dBm.
5.6 LAN Setup
According to actual needs, you can choose on or off the DHCP server, and also modify the DHCP
address pool range.
5.6.1 LAN IP Address
The IP address of LAN port is used for access AP itself by computers that connect to the AP directly;
here you can set IP address you need. The IP address format is like XXX.XXX.XXX.XXX, and default
IP address is 192.168.1.1, the default subnet mask is 255.255.255.0.
- 50 -